Ballistic calculator: drop, wind and scope adjustment
Work out in advance what your bullet does on the way to the target. This calculator gives drop, wind drift, velocity and energy for every distance and turns them into clicks on your scope in MRAD or MOA. Pick your bullet from the list of over 1,000 bullets or enter your own load, add your zero, sight height and the weather, and print a DOPE card for the range.
The table is wide. Everything works on a phone, but it reads best on a laptop, desktop or tablet.
What you enter
Start with the bullet, the BC and the drag model. For boat-tail match bullets that is preferably G7, for flat-base bullets G1. Then the details of your rifle: muzzle velocity, ideally measured with a chronograph or radar, sight height from the centre of the bore to the centre of the scope, and the distance at which you zeroed. If you also enter the twist rate, the calculator includes spin drift.
Weather and air pressure
Temperature, pressure and humidity together decide how dense the air is, and so how hard your bullet is slowed down. If you use the pressure from a weather report, enter the altitude of the range as well, because that pressure has been corrected to sea level. If you measure it yourself with a Kestrel, choose "Measured at the range". The calculator shows the density altitude so you can compare it with your meter.
Scope adjustment in clicks
For your target distance you see straight away how many clicks to dial, for elevation and for windage. The words UP, DOWN, LEFT and RIGHT say where the point of impact has to move. Which way you turn the turret for that differs between scope brands, so follow the arrow on your turret. You choose MRAD or MOA and the value of one click, 0.1 or 0.05 mrad, or 1/4 or 1/8 MOA.
For each distance the calculator works out the scope setting that actually puts the bullet on the line of sight. That is not the same as dividing the drop by the distance, because adjusting the scope changes the whole trajectory. On level ground without wind the difference is negligible to well beyond a kilometre. On steep uphill or downhill shots, or in a strong head or tail wind, it can be a full click at 1000 metres.
Trajectory table, charts and wind table
The trajectory table gives the bullet's position relative to your line of sight for every distance, the correction as an angle and in clicks, velocity, Mach number, energy and time of flight. The table marks where the bullet enters the transonic zone and where it goes subsonic. The charts show the path, velocity, energy and drift. The wind table lists the correction for a full-value crosswind from 1 to 8 m/s, so you can quickly judge what a gust does.
DOPE card
The DOPE card puts your load, zero and conditions on one compact sheet, with elevation in clicks, spin drift and the wind correction per 1 m/s of crosswind for every distance. The card deliberately leaves out the wind of the day, so it stays useful on any day at the range. You can print it, save it as an image or keep the full trajectory table as a CSV file.
Spin drift, crosswind and Coriolis
At long range a few smaller effects start to count. Because of its spin, a bullet from a right-hand twist drifts slowly to the right, easily two to three tenths of a mrad at 1000 metres. A crosswind pushes the bullet not only sideways but also a fraction up or down, the aerodynamic jump. And at very long range the rotation of the earth plays a part. The calculator includes the first two as soon as twist rate and bullet dimensions are filled in. Coriolis can be switched on with your latitude and direction of fire.
For F-Class, PRS, hunting and ELR
The calculator was made for precision and long-range shooting, from F-Class at 300 and 900 metres and PRS stages at varying distances to ELR well beyond a kilometre. Hunters use it to see how much velocity and energy a bullet has left at distance. For reloaders it is a quick way to put two bullets or two loads side by side before testing.
How accurate is it
The calculator integrates the trajectory with the standard G1 and G7 drag models, the actual air density and the wind as a vector. Many ballistic apps work the same way. Even so, every calculation is a model. A BC is an average, your muzzle velocity changes with powder temperature, and every bullet behaves differently around the speed of sound. Expect small differences that grow with distance, and record your actual hits. A measured velocity and a BC you have checked at distance get you closest to what you see at the range. All calculations run in your own browser, nothing is sent anywhere.